Below are
instructions to remove the screw retainer from a PalmControl vise.
Removing the screw retainer in the Goliath and Titan vises is
similar.
|
1: To remove the screw retainer, open the jaws all the way until
they are out of the T slot. Be careful to hang on to both
of the jaws so that they do not fall. A
third hand is helpful. Have an assistant unscrew will you catch
the jaws at either end. |
2: Jaws and screw are removed |
|
3: The screw retainer can now be reached. |
4: Lift up on the retainer to remove it. |
|
5: Now line up the jaws while on your bench screw them
together. Remember one jaw has right hand threads, the the
other left hand. In other words, the jaws will not thread
on if reversed. To double check that you are threading a screw
end to its matting jaw, you may first try threading it on one
end of the screw or the other to see which it fits. |
6: Jaws are now held together with screw. |
|
7: Slide the jaw and screw assembly into the T slot. Be
careful to take your time to align the T carefully.
|
8: Vise is now ready for use in positioning. |
|
 |
NEVER - PUSH, FORCE OR HAMMER TO
ASSEMBLE OR DISASSEMBLE YOUR VISE! DAMAGE CAN OCCUR IF
FORCED! IN FACT, DAMAGE CERTAINLY WILL OCCUR IF
HAMMERED! |
